Digiplex DGP2-648BL Bedienungsanleitung PDF herunterladen (Seite 23)

Digiplex LED Keypad 19n

If your keypad emits a Rejection Beep, you may have chosen an

existing User Code or the Master Code used to modify or create the

code does not have access to the User Options or Area Assignment

programmed.

To view the programmed code, instead of entering the User Code in

Step 5, the first number of the code programmed will illuminate.

Press the

[U] key and the numbers will illuminate one at a time as

you press the key (numerical light 10 represents zero).

Table 1: User Options

4) Enter the 2-digit User Number (02 to 96) you wish to program.

The A

CCESS action light will flash for an unused code. If the code

is used, P

RG action light and the first number of the code will

illuminate. The A

CCESS action and area light will turn off.

5) Enter a User Code. If you do not want to change an existing one,

press the

[U] key until you reach User Options. Your keypad will

emit a Half Beep when it switches to User Options. Pre-existing

options will illuminate.

6) Program the User Options (Table 1 on page 19) by turning the

options “ON” or “OFF”. Once the options are programmed, press

the

[U] key to reach the Area Assignment. Your keypad will emit

a Half Beep when it switches to Area Assignment. Pre-existing

assignments will illuminate.

7) Program the Area Assignment (Table 2 on page 22). Press the

[V] key to return to User Options or press [ENTER] to save and

exit. Your keypad will emit a Confirmation Beep to confirm the

code’s acceptance.

DGP2648_EU08.fm Page 19 Friday, September 29, 2006 2:43 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Keine Kommentare

Digiplex DGP2-648BL Bedienungsanleitung Seite 23